No cost, No passwords, No popup ads, No AI
-- just hobbyists & pros helping each other
we earn from 'affiliate link' purchases

Home /
T.O.C. Fun
FAQs Good
Books Ref.
Libr. Adver-
tise Help
Wanted Current
Q&A's Site 🔍
Search

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Delrin Surface Finishing

Is there a way of doing surface finishing for a machined Delrin (Acetal) part so that the surface would not release any particles ?

Frank Liang
- Allen, Texas
1999

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

Finishing
Jobshops Capital
Equipment Chemicals &
Consumables Consult'g,
& Software