Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Hardfacing a steel cam

I need to repair and hardface a 100 lb. cam made out of steel. Since this the only time I will do this job, I have to choose between buying the ultrajet and the eutalloy torches. Which one should I choose?

Thank you,

Rene Abaroa
Maintenance Services - San Ysidro, California, USA
2004

Neither, in my opinion, Rene. There are dozens of firms in the jobshop business who not only have this equipment, but the experience with the process to do it right. Although equipment is necessary to do this finishing process, I think experience and skill will prove equally important, such that doing it on a one-off basis may not be the best approach. Good luck.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: