No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Need for hydrogen de-embrittlement

Is hydrogen de-embrittlement required to case hardened component of 5 mm thickness subjected to service load of 50 kgs. This part is fitted on bonnet latch assemblt of tractors. The case depth is 0.5-0.8 hardness is 50-55 hrc.

Regards,

Sachin Ramesh Chaphekar
product design - Mumbai, Maharashtra, India
2003

Yes.

Toby Padfield
Automotive suspension modules - Michigan
2003

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: