No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Composition of ADC12 Aluminum Diecastings

I need information about aluminum die casting specifically for ADC12 (equivalent to ASTM SC102A or SAE303). If possibble, the microstructure, alloy composition etc.

ASRI A.M.

Asri Amat Mokito
- Malaysia
1999

2005

ADC12

Component
Cu
Si
Mg
Zn

Wt. %
1.5¡ã3.5
9.6¡ã12.0
0.3¥H¤U
1.0¥H¤U

Component
Fe
Mn
Ni
Sn

Wt. %
1.3¥H¤U
0.5¥H¤U
0.5¥H¤U
0.3¥H¤U

Al : Remainder
Physical Properties
Metric

Density
2.7 g/cc

CTE, linear 20¢XC
21 £gm/m-¢XC

Heat Capacity
0.963 J/g-¢XC

Thermal Conductivity
92 W/m-K

Melting Point
515 - 580 ¢XC

Solidus
515 ¢XC

Liquidus
580 ¢XC

I hope this will be great useful to you

from
gv

Venkatesan.G
- Chennai, Tamilnadu, India

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: