No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

E M I Powder ( electro magnetic inductance powder )

Does anyone have any knowledge of powders that are emi. ( electro magnetic inductance)

I understand that there are some powders which would cut out radio waves so that they would not intefere. It is mainly used for junction boxes where motors are driven. The powder coating cuts off the emi so that the motors when operational does not affect any frequency nearby.

Has any one used this type before.

Puru Ramoo
Singapore

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: