No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Corrosion Comparison chart

1999

I need a comparison Chart for Salt Spray tests on the following coatings, at commercial thickness, that will show average hours to corrosion or red rust. The coatings in question are: Zinc plating with clear chromate- .0002 to .0006 thickness, Electroless nickel- .0005 thickness. Hard Chrome at .0002 to .0006 thickness, and Cadmium plating- .0002 to .0006. Whatever help anyone could give me would be appreciated.

Dave McKay

If you have technical information about corrosion, please respond.

Thanks

Samuel Perez Granados
- Mexico City, Mexico
2001

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: