No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Variation in Gold thickness from HCD to LCD

We manufacture imitation jewelry made of white metal and also brass.Efficiency of gold bath is tallying on brass and on white metal (pre weight and post weight of plating) but correct thickness not reporting in XRF MACHINE.

Even it reads thickness is not uniform throughout the job. Comments and Suggestions is appreciated.

Panjala Mukesh
fashion jewelry mfgr.
Hyderabad, India
2003

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: