No passwords, No popups, No AI, No cost:
we earn from your affiliate purchases

Home /
T.O.C.
Fun
FAQs
Good
Books
Ref.
Libr.
Adver-
tise
Help
Wanted
Current
Q&A's
Site 🔍
Search
ted_yosem
Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ
finishing.com -- The Home Page of the Finishing Industry


  pub
  The authoritative public forum
  for Metal Finishing since 1989

-----

Polishing a stainless steel sink




I have stainless steel kitchen sinks and I would like to polish the surface as it has dulled after 23 years of use. I will greatly appreciate all the help and suggestions I get.

Artee K [last name deleted for privacy by Editor]
- Calgary, Alberta, Canada
2003


Hello

I have the same question and was wondering if an answer had been provided.

Cheers,

Fritz S [last name deleted for privacy by Editor]
- Hobart, Tasmania, Australia
2004


How do I clean my stainless steel sink and get rid of scratches and dullness?

Dawn H [last name deleted for privacy by Editor]
- Calgary, Alberta, Canada
2004


Also looking to polish a stainless steel sink.

Sam Walters
- Kamloops, BC, Canada
2007



I also need this question answered (FYI: how to spruce up an scratched stainless steel sink). Surely there must be someone out there who knows the answer to this, even if only to tell us that it can't be done & we have to replace.
Thanks!

sallie jo wald
- kamuela, Hawaii
2007



Certainly folks, there is a way to remove those unsightly scratches, stains, rust and oxidation from 'brushed' Stainless steel sinks and appliances, and grills..Scratch-B-Gone to the rescue. Available at retailers throughout the US and Canada, Scratch-B-Gone does what the name implies..removes scratches and revitalizes older, worn surfaces. We say "If you can follow a straight line...You can remove scratches" Thanks

Barry Feinman
Barry Feinman
BarrysRestoreItAll
supporting advertiser
Carlsbad, California
barrysrestoreitall
2007


none
adv.
this text gets replaced with bannerText
spacer gets replaced with bannerImages



(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

Finishing
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g,
& Software


About/Contact  -  Privacy Policy  -  ©1995-2024 finishing.com, Pine Beach, New Jersey, USA  -  about "affil links"