No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Alodine 600 on Titanium

We have done a blend repair on a titanium fitting. We have been told to treat the bare areas with Alodine 600. Is this the correct treatment to use ?

Thanks,

Tim Garity
Aircraft maintenance - Lincoln, Nebraska, USA
2003

Tim,

Who told you to use this? Was it the aircraft mfg? Defer to them for what they have FAA approval for. I thought the Alodine family was for Aluminum. Titanium has lots of rules; don't nick with cad, don't clean with methanol.

Jon Quirt
- Minneapolis, Minnesota
2003

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: