PEOPLE helping each other -- No AI, no cost, no reg'n, no damn popups
(As an Amazon Associate & eBay Partner we earn from qualifying purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

Thread 230/86

Mechanical descaling vs chemical pickling in wire drawing

Despite many trials, we cannot achieve same performances in chemical pickling when processing with mechanical descaling machine. Problems appears in defects along the length of the drawing rod after a short production. We have changed type of lubricant and dies with no success. Is it technological true that mechanical descaling might substitute chemical treatment while maintaining all process parameters of wire drawing process ?. If not, what are the reasons ?

BENAMARA
- ANNABA, ALGERIA
2003
publicly reply to BENAMARA

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: