Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Electropolishing platinum-iridium alloys

I am interested in learning how to electropolish platinum-iridium alloys (Pt - Ir). I would appreciate any suggestions on what electrolyte, voltages, current densities, and cathode material to use for my project. Is a pretreatment required prior to electropolishing?

Jim Carlson
- Gilroy, California, USA
2003

Dear Jim, This question has been asked before on this website. I don't know of any electropolishing methods currently used for platinum or platinum alloys. For a large amount of information on working with platinum, you may want to check the Platinum Guilds technical website www.pgi-platinum-tech.com . Good luck,

Jim Sivertsen
- Alden New York
2003

Hi Jim,

I'm looking for an EP process (for PtIr 80/20), Do you already find a proper solution?

Regards,

Oded NISSAN
- Raanana, Israel
2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: