No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2024

-----

Connection of PC to FPC

I want a method of connecting a pc card with an FPC so that the pc card rests or is pressed onto the FPC in a held position. The contact needs to be on the non smt side of the pc. The product is a consumer sports product.

Mike Ramsay
Golfspeed international ltd - Christchurch UK, Hampshire, UK
2003

I'm an amateur custom knife maker and there seems to be a lot of disagreement about the value of titanium over stainless steel for a liner lock spring. I was wondering if anyone knew the down sides of using titanium the pros are well known but few people say anything about the cons. and help would be appreciated.

Bill Littleton
student/knife maker - Devon, Pennsylvania, USA
2003

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: