Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

How to explain item magnetic on only ONE side

Removed a set of magnets from an old hard disk. What is unique about these magnets, they are only magnetic on ONE side. The magnet is glued to a piece of ferrous material, but the ferrous material isn't magnetic. How is this done?

Ed Simpson
- Escondido, California, USA
2003

I'm not familiar with the application or technology, but I would assume that the magnet is a very thin disk that is bonded (perhaps autoclaved) to a heavier non-magnetic ferrous material like a 300 series stainless steel.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: