No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2024

-----

SEEKING COPPER PLATING OF S-5 BAR 95" LG

2003

LOOKING FOR SOMEONE TO COPPER PLATE S-5 DECARBURIZED BAR.

BAR IS 1/2" X 8" X 95".

COPPER PLATE ENTIRE BAR .02 TO .03MM. HEAT TREAT TO 200 DEG.C FOR 3 HRS. COPPER PLATE TO TOTAL THK. .06 TO .08MM.

RONALD SATTLER
- EAST PALESTINE, OHIO, U.S.A.

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: