Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Wanted: Shaft for Plastic Bearing

I am a product development engineer and am developing a new product for a larger company to manufacture and market. One of my needs is to have a bearing that is not damaged by water. For this bearing I need a Hard Anodized Aluminum Shaft. How do I procure HARD ANODIZED Aluminum Tube 3/8" OD for use as a shaft for a bushing service. Can I get this premade or do I have to send aluminum tube to an "anodizer"?

G. David Fetters
- West Lafayette, IN, USA
2003

2003

It needs to be sent out for hardcoat anodizing after any machining (cutting to length, chamfering, cutting of shoulders, etc.) is done.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: