Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

MICr20 plating alloy

We supply spare parts to a local Japanese co. The print specs a MICr20 finish. This finish was explained to be nickel-chrome. I have asked a couple of local suppliers about this particular alloy to no avail. We have used hard chrome for the short run. Would someone have an explanation. Thank you.

Blaine Borkowski
Tri-Mation Industries Inc. - Kalamazoo, Michigan
2003

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: