Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

TS16949

We received QS9000 status a few years ago and ISO14001 this year. Now automotive have come out with TS16949. I have reviewed some of the requirements forTS 16949 but, am totally confused. Is there anybody out there that has TS16949 Accreditation that could fax or e-mail me a sample, such as the requirement for "Laboratories (E520)". It sure would make my life a lot easier.

Rodney T [last name deleted for privacy by Editor]
automotive - Midland, Ont. Cda.
2002

Rodney,

I find myself in the very same confused state with our transition to TS. Did you receive a sample from your inquiry and if so, are you at liberty to share.

Regrds,

Dave B [last name deleted for privacy by Editor]
heat treating - Burlington, Ontario, Canada
2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: