Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Sulfuric and Nitric Titration of a Sulfuric/Nitric Acid Bath

I would like to determine the sulfuric and nitric acid concentrations independently in a sulfuric/nitric etch bath. The bath is prepared with 10.25 oz. sulfuric and 2.5 oz. nitric per gallon - balance water. The bath is used to etch/clean magnesium casting alloys. Unfortunately I'm a metallurgist and not a chemist... Any advice?

Holly Seppanen
- Bloomington, MN, U.S.A.
2002

I need the answer to this one too!

Lori
- Florence, South Carolina
2002

I'm also interested to know how to determine the concentration of both acids.

Goh Ping
- Singapore
2003

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: