Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Stainless steel for salt mill

I am looking for a metal or alloy that can be used to make salt & pepper mill. 316 casting, with strong corrosive resistance, is a good method, but it weighs nearly 2000 g. so it is too heavy. Is there any good suggestion?

Don Chan
- China
2002

I would advice you to use titanium and its alloys which undoubtedly will solve your problems.

Andrey Igolkin
- St.Petersburg, Russia
2002

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: