Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Chemical Etching of Tantalum Sheet

I am trying to chemically wet-etch tantalum sheet. What is a good method for doing this?

Jason White
- Atlanta, GA, USA
2002

Dear Jason,

Tantalum is soluble in hydrofluoric acid (HF). You can use a wide range of concentrations of HF. Be careful: HF is a very dangerous chemical.

Kind regards,

Sjamp van Esch
- Eindhoven, The Netherlands
2002

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: