No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Polishing Bike Rims, Frame and Attached Components

I have a 2001 Suzuki TL1000R. I am interested in polishing my entire rims, frame, swingarm and other components.

Could you please advise me from start to finish with this project to include needed materials. I have a high speed buffer and a Dremel ⇦ this on eBay or Amazon [affil links] if this would benefit me any.

Thanks in advance.

Tony Brown
- Baltimore, Maryland
2002

Hi, Tony. Although I doubt that anyone is going to virtually write a book on polishing your specific 'cycle "start to finish", there are many very good threads on this site about polishing rims, frames, and swingarms. I think if you start with letter 800 you'll be happy. Good luck!

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: