No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Measure of case depth with NDT methods and equipments for ion nitriding plasma

I would like to know, what is the better method to measure case depth got with process Ion Nitriding Plasma using NDT Equipments, instead of Metallographic analysis. Our objective is to get what is the case on ± 0.002 inch for steels and Iron products mainly. We reach a maximum of 0.040 inches, on our services using Ion Nitride Plasma. We would like to show our Treatment to our customers with a report of the substrate of case got.

Jose Juan Alvarez Seres
ANALYSIS - Monterrey , Nuevo Leon, MEXICO
2002

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: