Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

SPI #4 Finish vs. SPI A-B-C-D?

I have an old part spec. that calls out an SPI #4 finish. What does that correspond to in the present SPI "A-B-C-D, 1-2-3" finishes?

Rich M [last name deleted for privacy by Editor]
- Sinking Spring, Pennsylvania, USA
2002

March 31, 2008

Hi, Rich. letter 20910 answers your question and offers some background. Good luck.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: