Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Restoring finish to aluminum trim on Retro table

I have a 1950's retro table with 3.5 inch polished aluminum trim. Wear and tear has left gouges and scratches in it. What is the best method of restoring the finish on the trim?

Doug Giesinger
- Sherwood Park, Alberta, Canada
2002

Marine Aluminum Restorer and Polish
3m_aluminum_restorer

on eBay or

Amazon

(affil links)

Hi, Doug. Aluminum can be restored to brightness by buffing. Unfortunately, removing scratches requires polishing down to their full depth, which may be too deep to be practical. But good luck with it.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
April 14, 2010

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: