No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

RA to SPI comparison charts

Does anybody have an RA to SPI comparison chart?

Pete K [last name deleted for privacy by Editor]
- New Berlin, Wisconsin

March 31, 2008

Hi
I would be wery instrested in if you got any answer to your question

Does anybody have an RA to SPI comparison chart?

Regards

Heinrich Jørgensen
- Denmark

March 31, 2008

Hi, Heinrich. I'm not sure that there really is any direct equivalence. But letter 20910 does explain what the SPI standards are and where to get them. Good luck.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: