No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Chromating metal matrix composites

I am attempting to chromate conversion coat an aluminum silicon carbide MMC in an Alodine 1200s bath. The results are poor to say the least. The coating has a poor color, and becomes dusty after a few weeks, which annoys our customer.

If anybody has experience chromating MMCs, I would appreciate any advice you may have.

Matthew C. White
- Longmont, Colorado
2002

Over cleaning pulls the silicon carbide to surface.

Milt Stevenson, Jr.
Syracuse, New York
2002

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: