No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Seeking to recycle the effluent

Dear Sir/Madam,

We produce electro-plating effluent at 15 gallon/minutes. I want to know how many methods or systems can recycle back effluent into production. How about efficiency and operation cost?

Ali Mahyuddin
Johor, Malaysia

The ETP design should involve segregation of different effluents like chemical bath and rinse water and then treat them. This way cost involved will be low.
Regards

Dr.V.Ravi Chandran
- Chennai, Tamilnadu, India

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: