Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Surface finish values

Junior Sales Representative - Resintech, Camden, NJ
Nadcap Chemical Processing Auditor - PRI, traveling
Process Engineer / Chemist - Denver Metal Finishing, Colorado

Q. ASTM A109: COLD ROLLED STEEL STRIP, CALLS FOR DULL FINISH, 2B FINISH, AND 2BB FINISH. CAN SOMEONE INFORM ME THE CORRESPONDING ROUGHNESS VALUE, Ra FOR SUCH FINISH.

Thanks,

JIT GUPTA
- Wheeling, Illinois, USA

A. I believe 2B and BA are raw finishes and Ra varies depending on the mills producing them. As far as I know, there are no Ra standards for stainless steel finishes, 2B, 2D, #3, #4, #6, #7 or #8. Check with SSINA or NiDI.

Good luck!

Michael Liu Taylor
specialty stainless steel distributor - Dallas, Texas

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: