No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

How do I put a design/pattern on a stainless steel tabletop?

I am trying to put a pattern on a stainless steel table top. The pattern or design I am trying to get is overlapping circles (you may have seen this design on cafe tables or even in stainless steel elevators)...how do I go about getting this design onto the table top? What tools do I use, etc. -- I realize I may have to practice on something else before I try to do this on my first try.

Thanks,

Eric Von Lehmden
- Austin, Texas

Patterns can be embossed, mechanically polished or acid etched.

Good luck!

Michael Liu Taylor
specialty stainless steel distributor - Dallas, Texas

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: