Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Definition of MIL-C-10578 spec

Does anybody know the make up of MIL-C-10578 spec or where I could find it.

Steven Scarpin
- Melbourne,Victoria, Australia

Hello Steven!

Yes, indeed, that spec and so many others are available from the ASSIST website of the US Department of Defense. astimage.daps.dla.mil/quicksearch/

Good luck!
Lee Gearhart
metallurgist - E. Aurora, New York

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: