No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

HOW TO MAKE ELECTROFORMING

I have a small work shop for electroplating I will like some information how to electroform, If some one can give instructions

Thanks,

Margarita Massuh
Arte Plata - Guayaquil, Ecuador

This is a subject of more than a few lines. Buy a book.

James Watts
- Navarre, Florida

Hello Margarita!

While I agree with the wise Mr. Watts, there are some articles on the web that give an introduction to electroforming. There is an article in the Guidebook that Metal Finishing magazine has placed online, and the Nickel Development Institute has some technical information on electroforming. I'd suggest you start with these, and if you need more detailed information invest in a good book.

Good luck!

Lee Gearhart
metallurgist - E. Aurora, New York

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: