No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Rinse Water Cleanliness Recommendations

Are there published recommendations for purity of post process rinse waters? We would like to install controllers which regulate water flow based on conductivity but don't know a good starting setpoint. We wish to maintain or improve quality and production

Greg Dant
- Minneapolis, Minnesota, USA

Here's a little information I will give you from my upcoming new book...

[see Finishing.com's on-line library article: Cleaning & Rinsing Requirements for Powder Coating]

Hope this helps you.....

Bob Utech
Benson, Minnesota

Ed. note: Bob is the author of:
"High Performance powder Coating"
on eBay or AbeBooks
or Amazon [affil links]

----
Ed. note: Mr. Utech's outstanding response to this letter was of such general value that we moved it to our on-line library.

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: