No cost, No passwords, No popup ads, No AI
-- just hobbyists & pros helping each other
we earn from 'affiliate link' purchases

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Key Control Characteristics -- KCC

Could Someone please direct me to the Standard or Regulation concerning the KCC or (Key Control Characteristics) as used on Drawings?.

Thanks,

Robert Stone

Robert,

Go to your favorite web search engine and type: Key Control Characteristics into the search frame. You will find a wealth of info (including links) there.

Randall Fowler - Fowler Industrial Plating, LLC
Cleveland, Tennessee, USA

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: