Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Heat treatment standard

Hi,

Anyone know what HTS-117 stands for? If it is a standards table, where can I get hold of it?

Thanks,

Yong Wee Boon
- Singapore

Hello Yong Wee!

I don't recognize HTS-117 as any industrial standard for heat treating, at least not one in the States. My best guess is that it is an internal specification of some company: your customer, perhaps? Or their customer? When I come across those obscure notes on drawings, I'm often forced into the difficult task of asking for information up the supply chain. Good luck!

Lee Gearhart
metallurgist - E. Aurora, New York

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: