No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

How to do Copper Deposition for plated through holes

I'm building printed circuit boards, for prototyping, but I am looking for how to deposit copper over the copper tracks, and finally building plated trough hole... If somebody could help or give me any useful information.

THANKS,

Roberto de Alba Alvarez
- Guadalajara, Mexico

Hi, Roberto. Coombs' Printed Circuits Handbook ⇦[this on Amazon affil links] is the go-to reference for this and just about anything having to do with fabrication of circuit boards. Good luck.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
February 19, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: