Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Want plans for plating power supplies / rectifiers

I would like to see plans on how power supplies are built.
Both standard rectifiers and pulse plating units.

Richard Pupello
merchandiser
1996

See Radio Shack, Archer, Building Power Supplies, Cat. No. 276-5025, It's only 5 or 8 dollars.

Tom Pullizzi
Falls Township, Pennsylvania
1996

Hi, Richard. This is a popular subject. Please see letter 32439 for a start. Good luck.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
December 1, 2008

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: