No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Refining gold in electronics by leaving it behind and dissolving the copper

I have a large amount of gold plated electrical contacts....I'm trying to decide whether to just use my nitric to dissolve the copper, or use an aqua regia solution to dissolve the gold and try to recover it that way...any suggestions would be greatly appreciated, have watched MANY postings on this site, all have varied greatly...have never seen one on dissolving the base metal and leaving the values !

Patrick Doyle
Hobbyist - LakeBay , Washington, USA
December 17, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: