Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Blow Holes

Could you please give me all the various reasons why blowholes are caused?

Vijay Satyanarayanan
Student - Coimbatore, Tamil Nadu , India
2005

Because evolution or intelligent design decreed that mammals that live in the water would survive better breathing through a hole at the top of their body :-)

If the blowholes are related to a metal finishing problem, Vijay, could you please describe the situation? It is very difficult for us to contribute usefully when we don't know if you're talking about welding, or defective castings, or pinholes in powder coating, or defects in plating adhesion or what. If you are having a real world problem please tell us the real world problem. Thanks!

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2005

I'll go with intelligent design, if it were evolution we would be sitting here arguing over which came first, the flipper or the blow hole.
(oops, I forgot to include my metal finishing question!)

Sheldon Taylor
supply chain electronics
Wake Forest, North Carolina
2005

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: