No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Chroming Martensitc and Austenitic Steels

Hi!

I'm looking for information about chroming austenitic steels. Specifically are there any differences in the steps from chroming a Martensitic steel?

Cameron Pflueger
fibre technologies - Montreal, Quebec, Canada
2005

I'm not sure if I understood your question or if I will have consensus or be corrected but I think the main differences in preplate and plate cycles arise from the chemical condition of the steel (i.e., contents of carbon and alloying elements basically chrome and nickel in excess of 2%) and not much from physical conditions like microstructure or hardness.

Guillermo Marrufo
Monterrey, NL, Mexico
2005

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: