No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Honda VTX Crusier Wheel Polishing

2004

Has anyone polished out to a mirror like finish 2002 Honda VTX 1800 cruiser bike alloy mag wheels with the wheels on the bike? If so what products and tools did you use and how difficult is this task?

Thanks

Harry Weis
Motorbike owner - Roseville, California, USA

Hi,I'm surfing the net trying to get the answer to the same question and I was wondering if you were successful in your hunt. If you were I was wondering if you could pass on the information to me.

Regards,

Gerald Tonner
- Seattle, Washington
2007

Use some tripoli compound on a small close-stitched polishing mop on a drill or flexi-shaft

Pete Durbin
- England
March 5, 2012

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: