No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Need non-outgassing black anodize

I have a customer that is requesting a unit be black anodized, and it must not out-gas, since it's going into an environmental chamber. would a hard anodize be what I'm looking for?

CARL M. ELISEO
electronics prototype (pcb/mechanical design) - RIVERSIDE, California, USA
2004

No out gas would be 0.00000 which is not possible even with Teflon, so what is the real criteria. Hard anodize would outgas less than regular anodize, but regular anodize is used in some types of environmental chambers, SO, what is the real criteria?

James Watts
- Navarre, Florida
2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: