Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ
The authoritative public forum
for Metal Finishing since 1989
-----
Electro Deburring
Tell me about electro deburring.
Bhavesh Patel- Rajkot, Gujarat, India
As you see from the silence following your letter, Bhavesh, most readers are not interested in writing chapters of books to answer questions that take 10 seconds to post. Please try your best to try to re-cast your inquiry as your own 'real-world' problem, rather than as an abstract flash-card question, and I think people will be happy to help you.
Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
Ted,
You should also mention that there are a number of ECD methods, which method to use depends upon what is the desired end result.
AF Kenton
retired business owner - Hatboro, Pennsylvania
(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)
Q, A, or Comment on THIS thread -or- Start a NEW Thread
Q, A, or Comment on THIS thread -or- Start a NEW Thread