comcomThe home page of the finishing industry ®
|
|
|
(12) Jessup plating barrels 16" x 42" w/slotted perf. Hardly used, in like new condition. $500.00 ea or best offer.
(posted 9/6/07) |
REcoNEW Products, Inc.
|
|
|
H&H
Equipment |
|
|
|
AUTOMATIC PHOSPHATE SYSTEM 2001 Automatic Jessup Barrel Phosphate System only used 4 years. Complete Automatic Jessup Barrel Phosphate System designed for a production rate of 7 - 8 loads/ hour on a barrel phosphate cycle, with a barrel size of 24" diameter x 60" long, 480 volt, 3 phase, 60 cycle, Approximately 84' long x 13' wide x 17' high. This system includes One (1) programmed hoist cart shall be provided with a lift capacity of 4,000 lbs. for carrier and work and Nine (9) 316L stainless steel barrels shall be provided. Each barrel is 24" diameter x 60" long with 3/8" perforations and 1/4" GA. shell. The assemblies are complete with hoist pick-ups, drive gear, split cover, and 304 stainless steel superstructure. Controls based on an Allen-Bradley, SLC 5/04, programmable control with 32K of CMOS, RAM memory which is backed up by a plug-in EEPROM module. The RAM memory is supported by a self contained lithium battery with low battery alarm indicator. Allen Bradley, NEMA 4X Panelview, flat TFT touch screen for graphic programming of automatic cycles, immersion timers, display of hoist movement, load tracking, interlocks, on-board fault diagnostics and help information. The carbon steel tanks are constructed of 1/4" plate stock, fit corner to corner and double welded. The stainless steel tanks are constructed of 3/16" plate stock, fit corner to corner and double welded. The PVC lined tanks have all walls and over the rims covered with 3/32" material. The tank bottom is lined with 3/16" material. All outlets are flanged on lined tanks. Phosphate tank #10 equipped with a sloped bottom to drain. A phosphate coil cleaning system shall be provided and located at the end of the tank line. Package also includes an Oberlin Sludge Filter Press. Designed with an elevated load/unload shuttle system with a load station, cover removal station and (2) unload stations. The shuttle system includes structural steel track and semi-automatic shuttle cart with barrel drive. The shuttle track unload stations shall be split into two sections. One (1) complete push/pull type ventilation system shall be provided for this equipment, designed and constructed as follows: One (60) HP boiler system shall be provided to supply low-pressure (15-PSI) steam. The boiler shall be of the firebox type with a three-pass wetback design. The boiler is completely packaged at the factory with an IRI burner, low water cut-off, pressure/temperature gauges and relief valves all mounted on an insulated skid type base. System includes the following components: AUTOMATED HOIST, STAINLESS STEEL BARREL ASSEMBLY, PROGRAMMABLE SYSTEM CONTROLLER, TRACK AND FRAME STRUCTURE, PROCESS TANKS, TANK HARDWARE, LOADING & UNLOADING EQUIPMENT, DRYER, PHOSPHATE COIL CLEANING SYSTEM, VENTILATION SYSTEM, HEATING SYSTEM, BOILER SYSTEM FOB: MA PHOSPHATE SYSTEM LESS BOILER $137,000 BOILER SYSTEM $ 17,000 Contact Nationwide Installation Corp. (posted 10/9/08) |
Nationwide
Installation Corp.
|
|
Lanco Corporation is the leading supplier of Used Plating Equipment to the finishing industry, including:
Our equipment is in stock and ready to ship. Atotech 31 Station Automatic Hoist Line Jessup 36 Station Auto Barrel Line Napco 84 Station Double Lane Automatic Rack
Line for a current listing of inventory www.lanco-corp.com or call us at 888-248-8500 or 616-887-8300 (posted 9/24/08) |
|
Lanco Corporation |
|
HAND PHOSPHATING UNIT, HEATED, FREEMONT MODEL 900 SPECIFICATIONS AND PICTURE LINK: http://www.finishingtechnologies.net/FREEMONTUNIT.html (posted 9/19/07) |
|
Industrial
Finishing Technologies, Inc.
|
|
Used/new Udylite Stevens Model C oblique barrel plating line (Serial #953 including scale loader). This line was originally purchased about 40 years ago by the U S government. It was installed and initially ran for 2 weeks for part approval and lab research. The project was dropped and all equipment was dismantled and mothballed. This line never ran in production. It has been warehoused and still has the original protective grease on the gears. Everything, including all of the oblique barrels, is in new unused condition. PRICE: $65,000 or best offer LOADED ON TRUCK CALL OR EMAIL FOR LAYOUT & PICTURES
(posted 5/29/07) |
REcoNEW Products, Inc.
|
|
|
H&H
Equipment |
|
Powder Coating Line
CALL OR EMAIL FOR SPECS, MORE PICTURES, AND PRICING (posted 6/11/08) |
REcoNEW Products, Inc. [Howardstown, KY]
|
|
SIX(6) NORDSON AUTOMATIC VERSA SPRAY 2 GUN SETS WITH AUTOMATIC TRIGGERING SYSTEM SPECIFICATION AND PICTURE LINK: http://www.finishingtechnologies.net/GUNS.html (posted 11/3/07) |
 |
Industrial
Finishing Technologies, Inc.
|
|
COMPLETE USED FREE RAIL BATCH POWDER COATING SYSTEM FOR LARGE OR RACKED PARTS SPECIFICATION AND PICTURE LINK: http://www.finishingtechnologies.net/FREERAILBATCHSYSTEM.html (posted 9/18/07)
|
| |
|
NORDSON THREE(3) BOOTH POWDER BOOTHS FROM STEELCASE WITH TOP OF LINE CONTROL SYSTEM, RECIPS, AUTO GUNS BOOTH MOVERS....ETC. SPECIFICATION AND PICTURE LINK: http://www.finishingtechnologies.net/STEELCASESPECS.html (posted 9/18/07)
|
| |
|
OVERHEAD POWDER SYSTEM - 3' X 5' OPENINGS - 4 FPM DESIGN LINE SPEED, 5 STAGE STAINLESS STEEL WASHER, (2) MANUAL BOOTHS SPECIFICATIONS AND PICTURE LINK: http://www.finishingtechnologies.net/IFSSYS.html (posted 9/18/07) |
| |
|
OVERHEAD POWDER COATING SYSTEM - 24" X 30" OPENINGS - DESIGNED FOR HEAVIER PARTS - 6 FPM DESIGN LINE SPEED - 5 STAGE STAINLESS STEEL WASHER WITH DI SYSTEM - EV ROOM - GEMA AUTOMATIC POWDER BOOTH SPECIFICATIONS AND PICTURE LINK: http://www.finishingtechnologies.net/OSISYSTEM.html (posted 9/18/07) |
| |
|
OVERHEAD POWDER SYSTEM - QUALITY MANUFACTURED BY RAMCO - 24" X 52" OPENINGS - 12 FPM DESIGN LINE SPEED - 3 STAGE STAINLESS STEEL WASHER - IPE AUTOMATIC POWDER BOOTH WITH RECIPS AND 4 COLOR MODULES SPECIFICATIONS AND PICTURE LINK: http://www.finishingtechnologies.net/RAMCO.html (posted 9/18/07) |
|
|
|
H&H
Equipment |
|
|
REcoNEW Products, Inc. |
|
RECTIFIERS FOR SALE (1) Aldonex 7,000, 0-12, 3ph, 220 input, air tap switch
and full controls. (4) Rapid each 5,000 6/12v with remotes, 220 input with
large pneumatic reversing switch from a large chrome shop,
60 cyl, 3ph, 60kw, SO S5012, Serial 76693, plenty of 1/4 x 4
buss copper air cooled. Can be sold separately if you'd
like. (1) Dynapower 5,000 DO-18, water cooled. Factory refurbished. (1) 12,000 0/15 w air hydraulic, reversing switch. Old but a workhorse. Rapid 6v, 3,000, 220, air cooled. Good cleaner unit. AIR SCRUBBERS FOR SALE 21.500 CFM (posted 11/14/08) |
Spencer Sales
Company |
 |
|
AP D.C. Power Supply |
|
Reconditioned power supplies in all sizes. Parts for all manufacturers.  |
|
Don Morgan Co.,
Inc.
|
|
More than 50 reconditioned rectifiers in stock |
|
H&H
Equipment |
|
| ||
|
Lanco Corporation is the leading supplier of Used Power Supplies to the finishing industry. Our rectifiers are thoroughly inspected and tested to assure quality products to our end users.
Our equipment is in stock and ready to ship. for a current listing of inventory www.lanco-corp.com or call us at 888-248-8500 or 616-887-8300
|
  |
Lanco Corporation
|
|
CAUSTIC SODA I have two or three drums of caustic soda in my garage -- zip code 19343. I am offering these to anyone to pick up for free -- strongly prefer to give these to someone who will take all of them and will use responsibly. Email lindert8m _AT_ gmail _DOT_ com. First bona fide answer takes it. Erich Linder |
|
|
H&H
Equipment |
|
FEEDER BOWLS
for a current listing of inventory www.lanco-corp.com or call us at 888-248-8500 or 616-887-8300 (posted 10/17/07) |
|
Lanco Corporation |
|
|
Spencer Sales
Company |
|
WASTE TREATMENT SYSTEM, HAVILAND
Have photos, must be seen!
(posted 11/14/08) |
Spencer Sales
Company |
|
| ||
|
Lanco Corporation is the leading supplier of Used Waste Treatment Equipment including:
Our equipment is in stock and ready to ship. for a current listing of inventory www.lanco-corp.com or call us at 888-248-8500 or 616-887-8300 (posted 12/4/07)
|
   |
Lanco Corporation
|
|
REVERSE OSMOSIS (RO) SYSTEM, 200 GPM, FROM IBM SPECIFICATIONS AND PICTURE LINK: http://www.finishingtechnologies.net/ROSYSTEM.html (posted 9/19/07) |
|
Industrial
Finishing Technologies, Inc.
|
|
(9) Never used 1200MM Gasketed Filter Press Plates for Shriver Filter Press. Plates manufactured by Micronics and are low pressure (125 psi) and the cake thickness is 32 mm. Uses Style 807 cloths. $300 each now. New $900 each. CALL OR EMAIL
|
|
REcoNEW Products, Inc.
|
|
|
H&H
Equipment |
|
| |
|
| |
|
| |
|
|
The cost of a Ad in this directory of Used and Surplus Equipment & Chemicals is $45 per month. To place your Ad on line <--click here. Substantial discounts available for listing of multiple items.
